5 replies [Last post]
rmichel13
rmichel13's picture
 Offline
VBMWMO #9224
Joined: 01/26/2017
Posts: 17

I am working on a 1974 r/60/5. I had the heads Honed and the valves reset and installed new rings. After reassembling the bike the left cylinder blows out a lot of smoke. I dissembled it and rechecked the rings and cylinder. I found 2 things 1: there was some oil between the piston and the head. and 2:that I installed the oil ring in backwards. After reinstalling the cylinder I still get smoke from the tailpipe and after turning off the ignition some oil leaks from the exhaust connection. Any Ideas?

__________________

Bob Michel

rmichel13
rmichel13's picture
 Offline
VBMWMO #9224
Joined: 01/26/2017
Posts: 17
Spacer Question

on a r60/2 can anyone tell me the thickness of the crank shaft spacer part # 110210016226. This goes on the rear of the crank between the rear bearing and the rear slinger.

Thanks

__________________

Bob Michel

schrader7032
schrader7032's picture
 Offline
VBMWMO #7032
San Antonio, TX
Joined: 10/27/2006
Posts: 6652
I'm a little confused. Is it

I'm a little confused. Is it a 1974 model or an R60/5? I see in previous posts, you mention an R60/6. Also, I can't find that part number...too many digits.

__________________

Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2

rmichel13
rmichel13's picture
 Offline
VBMWMO #9224
Joined: 01/26/2017
Posts: 17
Spacer

Thanks for your response. I have finished the r60/5 It is my nephews bike. I am now rebuilding r60 /2 motor I have had for years. Sorry about the part # I re-looked it up. The proper # is 11 210016266

__________________

Bob Michel

schrader7032
schrader7032's picture
 Offline
VBMWMO #7032
San Antonio, TX
Joined: 10/27/2006
Posts: 6652
I've never been this deep in

I've never been this deep in one of these engines, but this page in RealOEM mentions 2.0mm:

https://www.realoem.com/bmw/enUS/showparts?id=0223-USA-01_1967_T60_BMW_R...

__________________

Kurt in S.A.
'78 R100/7 '69 R69S '52 R25/2

rmichel13
rmichel13's picture
 Offline
VBMWMO #9224
Joined: 01/26/2017
Posts: 17
spacer

Thanks that's what I needed to know. I had to tear the motor completely down. The rear bearing went out caused the motor to knock. I took it apart about a year ago and am just getting around to putting it back together. I appreciate the help.

__________________

Bob Michel

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.